Go to the Projects page for additional details
Here is a list of many of the project completed during the refit haul out.
- DC electrical
- installed ACR for charging batteries
- installed 1-2-both & 0-1 switch system with two battery banks (via Maine Sail)
- installed LED festoon bulbs in cabin
- installed new steaming light on mast with new mast wires
- repaired spreader lights
- repaired stern light with LED bulb and new perks lens
- installed alternator Ampteck S120Si (also backup Db Electrical Ahi0059 Alternator For Yanmar Diesel Hi-Output 80 Amp Lr180-03)
- rigging
- installed new mast step
- installed new Davis wind index
- waxed mast while mast was unstepped
- added 1st reef line to boom
- hull
- repaired keel fairing
- replaced all below water thru-hulls
- replaced all seacocks
- barrier coated bottom with 5 coats of interprotect 2000E
- 2+ coats of Petit Ultima SR-60 green
- installed stainless rod for rudder line diverter
- drilled and drained rudder
- steering
- dropped rudder, cleaned and greased rudder tube
- replaced rudder thrust bearing backing plate
- replaced thrust bearing
- replaced cockpit sole access port to rudder tube
- replaced steering cables
- removed and repaired steering radial quadrant
- removed and reinstalled pedestal
- repaired steering brakes
- replaced Edson steering idlers
- propulsion
- rebuilt Yanmar 3QM30
- installed new Centek vernalift 1500026 (2” side-in/ 2” top-out)
- replaced cutlass bearing
- replace stuffing box hose
- removed, drained, cleaned, inspected, painted fuel tank
- replaced fuel sender
- deck
- replaced deck drain hoses
- replaced scupper drain hoses
- replaced missing teak toe rail and rub rails
- removed, stripped and painted all stanchion bases
- reinstalled stanchions with Dyneema lifeline.
- painted stern vent scoop with Kryon Fusion
- painted deck with Brightsides & Kiwigrip nonskid
- replaced fixed ports
- glassed in 4 old electronics holes by companionway
- removed all deck hardware, epoxy filled holes & and redrilled
- installed new hatch covers (winter green)
- topsides
- installed new swim ladder
- grind & fair damaged topsides
- spot paint topsides areas, wet sand, buff, and wax
- added documentation name and hailing port
- electronics
- installed Ubiquiti BULLET-M2-HP WiFi on masthead and 12V WiFi router
- installed new Metz Manta-6 VHF Antenna
- installed VHF/DSC radio with AIS an GPS and raymarine remote mic
- installed raymarine e7d chart plotter with thru-hull transducer
- installed raymarine i40 speed/log/temp thru-hull
- installed raymarine spx-5 wheel autopilot
- cabin
- installed 16,500 BTU/hr Flagship Marine AC
- replaced lower forward bulkhead in head
- installed jabsco head
- removed v-birth water tank to provide addition storage space
No comments:
Post a Comment